I Can Work This Thing!

Download this file
Click here to download

ALINCO DJ-S11 DATA

The DJ-S11 is a handheld 2M FM amateur radio transceiver with 20 channels (0-19) + CALL Channel; transmits up to 0.45 W on 144-148 MHz (receives 136-174) via 3 internal AA batteries or 4.5 VDC ex-ternal supply. The Battery icon in upper right corner of Display flashes when battery voltage is low. The folding antenna must always be in fully extended position & straight up when transmitting.

TO TURN UNIT ON & SET AUDIO VOLUME: Use DIAL on top right.

TO SELECT FREQUENCY:
To cycle between VFO & Memory Modes, push V/M(MW). Memory Mode is indicated by M & Channel Number in Display; VFO Mode by frequency only. Tune via UP or DOWN keys.
To tune VFO in 1 MHz steps, push F (lowest button on left side of case) & UP or DOWN key.
To tune VFO in 100 kHz steps, push F twice & UP or DOWN key.
To Scan frequencies/channels, push & hold V/M(MW) or SCAN/SHIFT. UP or DOWN, held in 1 second, changes scan direction. Same or PTT deselects. When audio tones activated, unit emits beeps as markers when tuning/scanning: double beep (rising or falling) at MHz, single at 0.5 MHz.

TO SET REPEATER OFFSET. Push & hold F & push SCAN/SHIFT. Again push SCAN/SHIFT to cycle among +, -, & Simplex. Push PTT to set. “T” appears in Display when PL tone is turned on.

TO SET PL TONES:
Push & hold F & push DOWN. Again push DOWN to select one of 50 subaudible transmit tones.
Push & hold F & push DOWN to turn tone on/off (indicated by “T” in Display) Push PTT to set.

TO ENTER A FREQUENCY IN A MEMORY CHANNEL:
Enter VFO Mode & select characteristics (frequency, offset, PL Tone On/Off, tone frequency).
Push & hold F & V/M(MW); use UP or DOWN key to select desired channel. (M & Channel Number/C flash in Display on channels not yet programmed.) Push V/M(MW) to set memory.
To erase memory, select channel, push & hold F & V/M(MW), again push & hold F & V/M(MW).

TO SET TRANSMIT POWER: While transmitting, push SCAN/SHIFT. Confirmed by L in Display.

TO DEACTIVATE SQUELCH MOMENTARILY: Push MONI.

TO USE LAMP: Push LAMP (second button from bottom on left side of case) momentarily.

TO SET BEEPS:
TRANSMIT ALERT: While transmitting, push UP or DOWN. Alternate this tone between a 1750 Hz steady tone & a telephone ring tone by holding in CALL/BELL while turning unit on. The tone selected for transmission is replicated in the speaker of the DJ-S11.
AUDIO TONES (receive alarm, key strokes): Hold in MONITOR while turning on. Same cancels.
RECEIVE ALARM (Carrier activates 3 “telephone” rings): Push & hold F & push CALL/BELL. This setting self-cancels after one ringing cycle and must be manually reset if desired again for later.
TRANSMIT GO-AHEAD: Hold in UP while turning on power. Same with DOWN cancels.

TO RESET ALL SETTINGS (channel memories are lost): Hold in F while turning on POWER.


Disclaimer: The information on this site is provided as a public service to the blind and visually handicapped community. While we have done our best to ensure the information provided is accurate, please realize the use of any information on this site is solely at your discretion and we take no responsibility for use or attempted use of this information.


Copyright © 2003-2015 Bibles for the Blind, Inc.
Report Errors and website comments to support@optimusmedia.com

Hosted by OptimusMedia.com