ADI AT-200 DATA
The AT-200 is a handheld 21-channel FM amateur radio transceiver
able to transmit up to 5 W on 144-148 MHz.
Receive range is extendable to 130-174 MHz. Operates with
power from 5 to 16 VDC via internal battery pack or external
supply. On case Top are (L-R) the SQUELCH, ON/OFF/VOLUME,
& TUNING DIALS. On the Face are LAMP, CALL, & SQL
Disable Buttons. On Left are PTT & F (FUNCTION = small
bump at top of PTT) Buttons.
TO SELECT FREQUENCY:
To cycle betwn VFO & Memory Modes, push MR/ENT/#. Memory
Mode indicated by M & Channel Number in Display. Dial
tunes VFO or 20 memories (Memory channels designated “M0-M9”
& “M0-M9 overlined”).
To tune VFO in 1 MHz steps, push & hold F (or push the
A/MHz Button) & rotate Dial.
Push 8/PWR/PL to cycle among Transmit Power Settings: High
(5 W), M (2.5), & Low (0.35).
To set repeater offset direction, push & hold F &
7/+/-/BS; cycles among +, -, & Simplex.
To Scan VFO, push C/VSCAN. To Scan memories, push D/MSCAN.
Same or PTT stops.
TO SELECT & TO TURN ON/OFF PL TONE (CTCSS):
To select tone, push & hold F & push 0/Set. Then push
4/CTCSS. Select desired PL Tone using DIAL. Push MR/ENT/#
to set selected tone & return to previous mode.
To turn CTCSS Tone On/Off, push & hold F & 4/CTCSS;
cycles among T, T.SQL, and Off.
TO ENTER A FREQUENCY IN A MEMORY CHANNEL:
Enter VFO Mode (push MR/ENT/# Button) & select characteristics
(freq, offset, CTCSS tones). Push & hold F & push
MR/ENT/# Button. Then push number of channel to be programmed.
ADI/Premier/Pryme Communications
20277 Valley Blvd, Unit #J Walnut CA 91789 Tel (909) 869-5711
Fax (909) 869-5710
IMPORTANT – READ BEFORE USING THIS GUIDE!
This guide has been prepared as a public service to provide, on one page, certain limited, highly general, simplified data about radio hobby equipment, especially for persons with disabilities or challenges. This is not a complete manual. No one should use any electronic or electrical equipment without first becoming fully aware of all data in the original manual. Failure to understand data in the original manual may result in injury or death to the user and others, damage to the equipment, operation in violation of FCC and other laws and regulations, and other serious consequences. There is no warranty of this guide’s accuracy, completeness, or conformity to manufacturer’s standards. Its use is strictly at the user’s discretion and risk.